Opening Your Trailer; Closing Your Trailer; Adjusting The Suspension; Attaching The Wheels - Burley Cub X Manual De Instrucciones Y Seguridad Del Propietario

Opening Your Trailer

1. Lift upper frame at rear (Figure 1).
2. Pull middle frame tube towards you (Figure 2).
3. Squeeze frame tubes together to latch securely in
place (Figure 3).
NOTE: Opening the trailer is easiest when the seat is in
the most reclined or middle recline position.

Closing Your Trailer

1. Remove passengers and cargo, and then remove the
tow bar and both wheels.
2. From the front of the trailer, lift the cover then press
the yellow release latches and pull the rear frame
through (Figure 4).
3. Fold flat.
NOTE: Damage to windows can occur if trailer is folded
with wheels installed.
WARNING
Care must be taken when folding and unfolding to
prevent finger entrapment.

Adjusting the Suspension

1. There are 5 adjustment set points (Figure 5). Rotate
adjustment knob to set suspension. Top position is
for lightest loads, bottom position for heaviest loads.
Trailer should be used with left and right suspension
set the same.

Attaching the Wheels

1. Push in the rubber button on the outside of the wheel
hub (Figure 6).
2. Insert wheel axle into axle receiver, and then release
the button (Figure 7). Pull firmly on wheel to confirm
the axle is fully engaged.
Figure 5
OWNER'S INSTRUCTION & SAFETY MANUAL
Figure 1
Figure 2
Figure 6
BURLEY.COM
Figure 3
Figure 4
Figure 7
5
ENG