Before First Use - VOX electronics WK-1711 Manual De Usuario

20. To protect from electrical hazard, do
not immerse the kettle, power base or
cord set in any liquid.
21. The kettle is only to be used with
the stand provided.
22. To protect against fire, do not
operated in
explosive and/or flammable fumes.
23. The appliance must not be immersed
in water.
24. This product is not designed for any
other uses other than those specified
in this booklet.
25. This appliance is intended to be
used in household only.

Before first use

Before first use, fill the kettle with clean water to maximum capacity and boil.
Discard the water and repeat the process.
Operation
1. The kettle
unplugged when filling or adding
water.
2. Fill the kettle with water to desired lev-
el. Do not overfill or there will be a risk
of spillage or spitting. The water level
indicator will assist you to measure the
correct amount. You can fill the kettle
via the spout or after opening the lid. Do
not forget to close the lid after filling;
otherwise the kettle will not automati-
cally switch off after use.
3. Do not fill with less than 0.5 litres of
water（to "min" indication）to prevent
the kettle running dry while operating.
4. Do not fill with more than 1 litre of
water（to "max" indication）.
5. An automatic safety cutout has been
fitted for protection against overheating;
it will operate if the kettle is switched
the presence
should always
26. Save
further reference.
27. Never let the kettle operate while
unattended.
28. Switch off the power supply and discon-
nect from mains supply when not in use,
before cleaning or other maintenance.
of
29. Never touch the hot parts of the
appliance.
30. Steam will cause burn. Be careful
when opening the lid with hot water.
31. Always turn off and unplug the
kettle when it is not in use.
32. Avoid using an extension cord,
extension cord may cause risk of fire
because of overheat.
be on when containing insufficient water.
Always ensure the water inside the
kettle covers the minimum mark on the
water level indicator gauge. If the
automatic safety cut-out has operated,
switch the kettle off, disconnect from
the power outlet and allow the kettle to
cool down for 5 to 10 minutes. The refill
with and switch on, the kettle will work
as normal.
Place the power base on a dry, flat
6.
surface. Place the kettle on the power
base. The electrical connection will be
made automatically as the kettle slides
onto the power base.
Plug the cord set into an earthed power
7.
socket and switch on by pressing the
on/off switch of the kettle to the "on"
position.
these instructions for