Burst Or Vertical Steam Ironing; Dry Ironing; How To Clean And Store - VOX electronics DBL-5030 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 29
SPRAYING
– Press the spray button to spray water on clothes, as often as required.
Note: When using the water spray function, ensure that there is enough water in the
water tank, and you may have to pump the spray button serval times at first time you
use the iron in order to start the spraying function.

BURST OR VERTICAL STEAM IRONING

– Press the burst of Steam button to generate a powerful burst of steam that can
penetrate the fabrics and smooth the most difficult and tough creases. Wait for
a few seconds before pressing again.
– By pressing the Burst of Steam Button at intervals you can also iron vertically
(curtain, hung garments, etc.)
Note: The burst steam function can only be used at high temperature. Stop the
emission when the pilot light turns on, then start ironing again only after the pilot light
has turned off.

DRY IRONING

For ironing without steam, follow the instruction in section "steam ironing", however,
the steam control turning knob should remain in position "OFF" (no steam).
SELF-CLEANING
The self-cleaning feature cleans inside the soleplate, removing impurities. We
recommend using it every 10-15 days.
– Set the steam control turning knob to position O (no steam).
– Fill the water tank to the maximum level.
– Set the temperature control dial to MAX and wait for the pilot light to turn off.
– Pull the plug out of the socket and press the self-cleaning button until the boiling
water, steam, impurities come out.
– When the soleplate has cooled down, you can clean it with a damp cloth

HOW TO CLEAN AND STORE

– After using, lift the iron with the filling hole downwards to empty the remaining
water from the Water tank.
4

Publicidad

Tabla de contenido
loading

Tabla de contenido