Troubleshooting Guide; Safety Precautions; Warranty Information - Peach Silver Line PL714 Instrucciones De Funcionamiento

1
Description
A Main switch
B Laminating film entry
C Laminating film exit
D Ready for laminating
How to use
1 Plug in AC power
2 Turn on the power
3. Position document/photo inside laminating film
4. Start when "Ready for laminating" glows
5. Insert the laminating film (with sealed side first)into film entry
6. Take out the laminated document/photo from the laminator's rear
Be careful, it might be hot.
7. If the lamination is not perfectly sealed repeat step 5 and 6
8. If you are not planning to continue laminating for a while, switch off the
laminator. This will guarantee higher quality lamination, everytime

Troubleshooting Guide

Problem
Machine has no power
or is not running.
Excessive noise
Bad laminating
Corners are not sealed

Safety precautions

! Do not allow articles of clothing (neckties, scarves, etc.) near the front or rear machine openings as they could get caught by the rollers and be pulled inside,
causing serious personal injury.
! To prevent the possibility of electric shocks, do not immerse the machine in water or allow liquid to spill inside.
! Close supervision is necessary when any appliance is used by or near children.
! The socket outlet must be installed near the equipment and must be easily accessible

Warranty Information

2-YEARS LIMITED WARRANTY IN EUROPE
PEACH OFFICE PRODUCTS laminating equipment is warranted in Europe for a period of two years from the date of the purchase. Laminating supplies are
excluded from the warranty. Defects or device failures which have been caused by incorrect or wrongful use, regardless whether unintentional or intentional,
or non-compliance with the manufacturer's instructions during the operation or maintenance of the device are excluded from the warranty. In the event of
returning the machine to Peach, suitable packaging must be used. Peach will not accept liability for the loss of, or damages to, the machine during delivery
when unsuitable packaging has been used.
For service of the unit under warranty, please contact:
PEACH OFFICE PRODUCTS European customer service:
Tel.: +41-44-787 68 60
Fax: +41-44-787 68 68
E-Mail: support@peach.info
Cause
Power plug is not pluged in. Power switch is off.
Operation of gear is not smooth
Laminated document wrinkled, damp or folded
Document is to thick to seal the edges of the
film
Solution
Check the Power plug is properly plugged. Check if
the Power switch is turned on or contact support
Turn off the machine, contact support.
Turn off the machine and wait 15 minutes before
switching back on.
Use a thinner document or leave more around the
edges, aprox 5 mm