Operation Instructions - Danby DDR070BBCBDB Guía De Utilización Y Cuidado Para El Propietario

Operating Instructions
CASTOR INSTALLATION
Castor installation is recommended to avoid damage to fl oors.
1. Remove the castors from the bucket of the dehumidifi er.
2. Position the dehumidifi er on its side.
3. Locate the arrow on the bottom of the dehumidifi er and insert the castor
according to the arrow direction.
4. Slide the castor in as far as it will go. The castor will snap into place.
5. Repeat steps 1 to 4 for the other 3 castors.
CONTROL PANEL INSTRUCTIONS
NOTE: The control panel of the unit you purchased may be slightly different depending on the model number.
1. Smart Dehumidify: This function will automatically adjust the humidity level with the fl uctuating room temperatures.
The humidity level cannot be adjusted in this setting, it will stabalize between 45% - 55%.
2. Filter Button: The check fi lter light will illuminate after 250 hours of operation to remind you to clean the fi lter. To reset
this function after cleaning the fi lter, press the fi lter button and the light will go off.
3. Continuous Button: Press to activate the continuous dehumidifying operation, which will run the compressor contin-
uously in order to pull as much water from the air as possible.
4. Fan button: Controls the fan speed. Press to select either high or normal fan speed. Set the fan control to high for
maximum moisture removal. When the humidity has been reduced and quiet operation is preferred, set the fan control
back to normal.
5. Timer Button: Press to initiate the auto-start and auto-stop feature. Set a start or stop time from 0.0 to 24 hours using
the ( ) and ( ) buttons.
Buttons: The humidity level can be set within a range of 35% RH (Relative Humidity) to 85% RH in 5%
6.
increments using these buttons. For drier air, press the (
damp air, press the (
7. Power Button: Press to turn the dehumidifi er on or off.
8. Display: Shows the actual (± 5% accuracy) room humidity level in a range of 30% RH to 90% RH. Otherwise, dis-
plays selection when programming humidity or timer.
Note: The fan does not shut off the moment you remove the bucket, the fan will shut off after 2-3 minutes.
10
3
1 2
) button and set a higher percentage value (%).
9 8
5 6
4
) button and set to a lower percentage value (%). For more
5
7