Factory Buys Direct FBDFA40 Manual Del Propietário página 6

1. Provide propane supply system (see
Propane Supply, page 5).
2. Connect POL fitting on hose/regulator
assembly to propane tank(s). Turn POL
fitting counterclockwise into threads on
tank. Tighten firmly using wrench.
IMPORTANT: Position regulator so that
hose leaving the regulator is in a hori-
zontal position (see Figure 3). This places
the regulator vent in the proper position to
protect it from the weather.
3. Connect hose to valve inlet (see Figure
4). Tighten firmly using a wrench.
IMPORTANT: Use extra hose or piping
if needed. Install extra hose or piping
between hose/regulator assembly and
propane tank. You must use the regulator
supplied with heater.
4. Open propane supply valve on propane
tank(s) slowly. Note: If not opened slowly,
excess-flow check valve on propane tank
will stop gas flow. You may hear a click
from the excess-flow check valve closing.
If this happens, reset the excess-flow
check valve by closing propane supply
valve and open again slowly.
Propane Supply
Valve
Propane
Tank
Figure 3 - Regulator Position
Inlet Connector
Figure 4 - Hose and Inlet Connector
6
INSTALLATION
5. Check all connections for leaks. Apply
6. Close propane supply valve.
BASE FEET [FBDFA40(-C) ONLY]
1. Locate 2 rubber feet and 2 screws in
2. Attach to bottom of base as shown in
Hose
To adjust the height of the front of the heater,
unscrew the fastener securing the support
bracket. Adjust bracket to desired height and
tighten fastener.
Regulator
POL
Fitting
Hose
www.factorybuysdirect.com
mixture of liquid soap and water to gas
joints. Bubbles forming show a leak that
must be corrected.
hardware package.
Figure 5.
Figure 5 - Attaching Base Feet
Model FBDFA40
SUPPORT BRACKET
[FBDFA60V(-C) ONLY]
Fastener
Support
Bracket
Figure 6 - Adjusting Heater Height
Model FBDFA60V
160944-02A