Colentris co70005 Manual Del Usuario página 5

For batteries with cell closures, remove the cell closures and check out the status of the battery charging. If the electrolyte
ź
level is below the recommended level, add distilled water.
For batteries without cell closures, carefully follow the manufacturer's charging instructions.
ź
Make sure that the vehicle's ignition is switched off (if the accumulator is connected in the vehicle).
ź
Connect the charger, always follow these steps:
ź
Insert the positive clamp of the charger (red) to the positive (+) terminal of the accumulator.
ź
Connect the negative clamp of the charger (black) to the negative (-) terminal of the accumulator.
ź
Plug the 230V plug into the mains.
ź
The charger automatically detects if a 6V or 12V accumulator is connected.
ź
When the 12V accumulator is connected, the MODE button allows you to select the charging modes.
ź
Thrifty charging mode – charging current 2A. Suitable for e.g. for 12V motorcycle accumulators.
ź
Standard mode – charging current 10A. Suitable especially for auto mobile accumulators.
ź
Winter mode – charging current 10A. Use this mode at temperatures below + 5 °C.
ź
The symbol indicates that the accumulator is being charged, the display shows the current charging voltage.
ź
Poor polarity or short circuit indicator light - disconnect the charger from the socket and connect the battery correctly.
ź
Once the accumulator is charged, charging is interrupted and the charger switches to maintenance mode where the
ź
microprocessor controls the pulse charging to keep the accumulator in a charged state.
Always disconnect the charger from the 230V mains and after then from the accumulator after charging.
ź
If you have opened the battery cell closures, you must close them again
ź
Heavily discharged and damaged car batteries can not be charged by using this charger. If the 12V car battery voltage drops
below 8V, the microprocessor in the charger will mark the battery as damaged and will not charge it!
If the 12V car battery voltage drops below an acceptable level, the charger can evaluate this car battery as 6V and will not
charge it properly!
The manufacturer does not take responsibility for accidents or damages resulting from non-compliance with this manual.
Changes in text, design, and technical specifications could be changed without previous warning and we reserve the right to
change them.
Do not dispose power tools and devices into the household waste!
According to European Directive 2012/19 / EC on Waste Electrical and Electronic Equipment (WEEE) and in the
enforcement of national law, used power tools must be collected separately and shipped to an appropriate
recycling plant.
co70005
Instructions for charging:
Warning:
Disposal and recycling
5