Sauna Heater Stones; Heating The Sauna; If The Sauna Heater Will Not Heat Up - Tylo Mega Line OC 90 Manual De Instalacion Y Uso

2.3. Sauna heater stones

Quality stones meet the following requirements:
1. Sauna stones should withstand heat and heat variation caused by vaporisation of the water thrown on the
stones.
2. Stones should be rinsed before use in order to avoid odour and dust.
3. Sauna stones should have an uneven surface to supply a larger surface for the water to evaporate from.
4. Sauna stones should be large enough (intended for large sauna heaters, approx. 60 - 100mm), to allow good
ventilation between the stones. This extends the useful life of the heating elements.
5. Sauna stones should be piled sparsely in order to enhance ventilation between the stones. Do not bend the heat
ing elements together or against the frame.
6. Rearrange the stones regularly (at least once a year) and replace small and broken stones with new, larger
stones.
7. Stones should be piled so that they cover the heating elements. Do not, however, pile a large heap of stones on
the heating elements. Please refer to the table on page 7 Table 2 for an adequate amount of stones. Any small
stones included in the stone delivery package should not be placed on the sauna heater, because they might fall
trought the heater's vertical beams. The warranty does not cover defects resulting from poor ventilation caused
by small and tightly packed stones.
Structural clay tiles are not allowed. They may cause damage to the sauna heater Damages caused by using
structural clay tiles will not be covered by the warranty.

2.4. Heating the sauna

Before turning the sauna heater on, make sure the sauna room is suitable for taking a sauna bath. When heated for
the first time, the sauna heater may emit some odour. If you detect any odour while the sauna heater warms up,
disconnect the sauna heater briefly, and air the room. Then you can turn the sauna heater on again.
The sauna heater is turned on from the control panel that has controls for the heating temperature and time.
The heating of a sauna should be started roughly an hour before you plan to take a sauna bath, so that the stones
have time to heat up properly and the air warms up evenly in the sauna room.
Do not put any objects on the sauna heater. Do not dry clothes on the sauna heater or anywhere in its vi-
cinity.

2.5. If the sauna heater will not heat up

If the sauna heater will not heat up, please check that:
- the power is on;
- the main fuses of the sauna heater are intact;
- is there any error messages on the control panel. In case of an error message on the control
panel, please refer to the control panel instructions.
- has the high temperature limiter in the sensor been triggered, Before pressing the reset button, the rea
son for the triggering of the temperature limiter must always be clarified!
Sensor
Restore
4