Controlling Other Equipment Using The Supplied Remote Control Unit - Pioneer KURO KRL-37V Manual De Instrucciones

Introduction
Controlling other equipment using
the supplied remote control unit
Using the supplied remote control unit, you can control
other equipment in connection: a set-top box (STB),
DVD player, DVD/HDD recorder (DVR), BD player or
VCR.
Before using this function, you need to preset the
supplied remote control unit with the manufacture
code of the equipment to be controlled. When you
then want to control the equipment, press SELECT
on the remote control unit to select an appropriate
mode depending on the equipment; the selection is
switched among TV, STB, DVD/DVR, and VCR. The
corresponding mode indicators on the remote control
unit show the currently selected mode.
HDMI
CTRL
CM SKIP
TOOLS
SOURCE
TV
NOTE
• When you control a BD player, select the DVD/DVR
mode.
Presetting manufacture codes
1
Press SELECT on the remote control unit
to select the STB, DVD/DVR, or VCR mode
depending on the equipment.
2
After confirming that the indicator of the
previously selected mode goes off, press and
hold SELECT, and then press 1 on the remote
control unit.
• The corresponding mode indicator flashes.
3
Press 0–9 to enter a three-digit manufacture
code.
• See the manufacture code list to identify an
appropriate code. The mode indicator lights up
for approximately one second and then goes off;
presetting the manufacture code is completed.
1
4
7
INFO
EXIT
CTRL
CM SKIP
SOURCE
TV
4
REC STOP
SCREEN AV
SIZE SELECTION
DVD HDD
SELECT
DVD
STB DVR VCR
2 3
5 6
8 9
0
P.INFO
DVD TOPMENU/
GUIDE
EPG
SCREEN AV
SIZE SELECTION
DVD HDD
TOOLS
SELECT
DVD
STB DVR VCR
NOTE
• If you perform no operation for approximately one
minute while a mode indicator is flashing, the code
presetting procedure is quitted.
• If you enter a code not listed in the table, a mode
indicator flashes quickly for approximately one
second and then flashes as before.
• To quit the code presetting procedure halfway
while a mode indicator is flashing, you may press
SELECT on the remote control unit.
• The factory default manufacture codes for the STB,
DVD/DVR, and VCR modes are "000", "100", and
"500" respectively.
Manufacture codes
* You may not be able to control some equipment
in the tables partially or entirely with the supplied
remote control unit.
STB
000 PIONEER 1 (factory default)
001 PIONEER 2
002 CANAL SATELLITE
003 HUMAX
004 PACE 1
005 PACE 2
006 QUALI-TV
007 SKY DIGITAL
DVD
100 PIONEER 1 (factory default)
101 PIONEER 2
102 AKAI
103 DENON
104 HITACHI
105 JVC
106 KENWOOD 1
107 KENWOOD 2
108 PANASONIC 1
109 PANASONIC 2
110 PHILIPS 1
111 PHILIPS 2
112 SAMSUNG
113 SHARP
114 SONY 1
115 SONY 2
116 SONY 3
117 THOMSON
118 TOSHIBA
119 YAMAHA