Extension Cords; Fcc Caution - Flex FX0411 Manual Del Operador

To reduce the risk of injury, close
supervision is necessary when an appliance
is used near children.
AN EXTENSION CORD
WARNING
UNLESS ABSOLUTELY NECESSARY. Use of
improper extension cord could result in risk of
fire and electrical shock. If an extension cord is
used, make sure:
a. The pins on plug of extension cord are the
Length of Cord (Feet)
Size of Cord (AWG)
Extension Cord Chart for 220/240 Volt Tools:
0.75mm CORD
2
1.0mm CORD
2
d. An extension cord is a temporary solution. Move the charger to a standard receptacle as soon as
the job has been completed.
1. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
SAVE THESE INSTRUCTIONS.

EXTENSION CORDS

SHOULD NOT BE USED
Do not use outdoors.
same number, size, and shape as those of
plug on charger.
b. The extension cord is properly wired and in
good electrical condition.
c. The wire size is large enough for AC ampere
rating of charger as specified below:
25 50
18 16
50 Meters
75 Meters

FCC CAUTION

and used in accordance with the instructions,
may cause harmful interference to radio
communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the
•
equipment and receiver.
Connect the equipment into an outlet on a
•
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
•
technician for help.
-4-
100 150
16 14