nvent Raychem SC-JBP-S-A Manual De Instrucciones página 3

3
• Lightly score outer jacket
around and down as
shown.
• Bend heating cable to
break jacket at score,
then peel off jacket.
5
• Push braid forward. Use a
screwdriver to open braid.
• Bend heating cable and work it
through opening in braid.
3SC heating cable shown.
7
• Pull heating cable back into stand as shown. Use
cable lubricant if needed.
Do not cut braid.
6 in.
(152 mm)
• Pull braid tight
to make pigtail.
4
• Push braid back as far as
possible.
• Lightly score inner jacket
around and down as shown.
6
3/4 in.
(20 mm)
Fiberglass
braid (only for SC, SC/H)
• Remove 3/4-inch (20 mm)
insulation and fiberglass
braid from end of each
conductor.
3SC heating cable shown.
5 in.
(127 mm)
• Peel off inner
jacket.
1-1/2 in.
(38 mm)
nVent.com | 3