RIDGID R4518 Manual Del Operador página 17

ASSEMBLY
MOUNTING THE TABLE SAW TO THE LEG
STAND
See Figures 11 - 12.
WARNING:
Do not lift the saw without help. The saw weighs
approximately 55 lbs. Hold it close to your body.
Keep your knees bent and lift with your legs, not
your back. Ignoring these precautions can result
in back injury.
 With the unit in the upright position, spread the legs of
the stand. Place stand on level ground.
NOTE: When positioning the stand make sure each leg
is spread fully outward to ensure the stand's stability.
 Hold the table saw at a slight angle and place the rear of
the saw onto the stand.
NOTE: The raised tabs on the stand should go over the
saw's frame and between the saw's feet. The saw's feet
should fit inside the corners of the stand.
 Once the rear of the saw is in place, lower the front of the
saw down and fit the feet inside the corners of the stand.
NOTE: Make sure the table saw feet are flush against the
stand and that all the stand legs are touching the ground.
 Slide the saw forward slightly and secure in place using
the latch on the front of the stand.
FOOT
RAISED
TABS
LATCH
17 − English
FOOT
Fig. 11
Fig. 12