Part Names And Functions; Rear Panel - PIONEER DJ DJM-750MK2 Manual De Instrucciones

Part names and functions

Rear panel

1
d
1 u button (page 11 )
Turns this unit on and off.
2 RETURN terminals (page 10 )
Connect to output terminals of an external effects unit. If a cable
is connected to the [L (MONO)] terminal only, the input to the
[L (MONO)] terminal is also input to the [R] channel.
3 SIGNAL GND terminal (page 9 )
Connect a ground wire of an analog player to reduce noise that
occurs when an analog player is connected.
4 PHONO terminals (page 9 )
Connect a phono level (MM cartridge) output device. Do not input
line level signals.
5 LINE terminals (page 9 )
Connect a DJ player or a line level output component.
6 MIC terminal (page 9 )
Connects a microphone.
Phantom power supply is not supported.
7 Kensington security slot
8 USB terminal
Connect a computer with a USB cable.
9 BOOTH terminals (page 10 )
These are output terminals for a booth monitor.
Be sure to use these as balanced outputs.
a MASTER2 terminals (page 10 )
Connect to analog input terminals of a power amplifier, etc.
b MASTER1 terminals (page 10 )
Connect to analog input terminals of a power amplifier, etc.
Be sure to use these as balanced outputs.
Be careful not to accidentally insert the power cord of another
unit.
Do not connect the terminal that can supply phantom power.
c SEND terminals (page 10 )
Connect to input terminal of an external effects unit. If a cable is
connected to the [L (MONO)] terminal only, a monaural audio signal
is output.
6
En
2 3 4 5
c b
4 5 4
a 9
d AC IN
Connect to a power outlet with a supplied power cord. Connect the
power cord after all the connections are completed.
Be sure to use the supplied power cord.
5 4 5
8
6
7