Regulatory Notices; Important Safety Instructions For All Battery Packs - DeWalt DXH12B Manual De Instrucciones

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
• Do not operate the charger if it has received a sharp blow, been
dropped or otherwise damaged in any way. Take it to an authorized
service center.
• Do not disassemble the charger; take it to an authorized service
center when service or repair is required. Incorrect reassembly may
result in a risk of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting any
cleaning. This will reduce the risk of electric shock. Removing the
battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 120V household
electrical power. Do not attempt to use it on any other voltage. This
does not apply to the vehicular charger.

Regulatory Notices

• This Class B digital apparatus complies with Canadian ICES-003.
• This device complies with Part 15 of the FCC Rules and Industry Canada
License-exempt RSS standard(s). Operation is subject to the following two
conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including
interference that may cause undesired operation.
• Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Introduction
The DCB107, DCB115 battery charger (Fig. 9) is designed to charge DeWALT
12–20V Max* lithium ion battery packs. This charger requires no adjustment
and is designed to be as easy as possible to operate. Simply place your
battery pack into a receptacle of a plugged in charger and it will automatically
charge the pack. Consult the chart at the end of this manual for compatibility
of chargers and battery packs.
IMPORTANT SAFETY INSTRUCTIONS FOR ALL BATTERY
PACKS
When ordering replacement battery packs, be sure to include the catalog
number and voltage. Consult the chart at the end of this manual for compati-
bility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before using the
battery pack and charger, read the safety instructions below and then follow
charging procedures outlined.
READ ALL INSTRUCTIONS
WARNING:
• Do not charge or use the battery pack in explosive atmospheres,
such as in the presence of flammable liquids, gases or dust. Inserting
or removing the battery pack from the charger may ignite the dust or fumes.
• NEVER force the battery pack into the charger. DO NOT modify
the battery pack in any way to fit into a non-compatible charger as
battery pack may rupture causing serious personal injury. Consult the
chart at the end of this manual for compatibility of batteries and chargers.
• Charge the battery packs only in designated DeWALT chargers.
• DO NOT splash or immerse in water or other liquids.
• Do not store or use the tool and battery pack in locations where the
temperature may reach or exceed 104 °F (40 °C) (such as outside
sheds or metal buildings in summer). For best life store battery packs in
11