RedMax CHTZ600 Manual De Usuario página 11

product until it is correctly adjusted or
repaired.
• The idle speed is correct when the engine operates
smoothly in all positions. The idle speed must be
below the speed when the cutting attachment starts
to turn.
1. Start the product, refer to
cold engine on page 9 .
2. Turn the idle adjustment screw clockwise until the
cutting attachment starts to turn.
3. Turn the idle adjustment screw counterclockwise
until the cutting attachment stops.
Note:
Technical data on page 14 for the
Refer to
recommended idle speed.
To clean the cooling system
The cooling system keeps the engine temperature
down. The cooling system includes the cooling fins on
the cylinder, the cylinder cover and the air intake
through the crankcase.
CAUTION:
fuel tank and crankcase, is easily blocked by
leaves. Clean the air intake fully.
1. Clean the cooling system with a brush weekly or
more frequently if it is necessary.
2. Make sure that the cooling system is not dirty or
blocked.
1074 - 004 - 30.01.2021
To start the product with a
The air intake between the
To examine the spark plug
CAUTION:
recommended spark plug type. Incorrect
spark plug type can cause damage to the
product.
• Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
• To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 14 .
• Replace the spark plug if it is necessary.
To clean the air filter
Clean the air filter regularly from dirt and dust. This
prevents carburetor malfunctions, starting problems,
loss of engine power, wear to engine parts and more
fuel consumption than usual.
1. Remove the air filter cover (A).
2. Remove the foam filter (B) and the felt filter (C) from
the filter frame.
B
A
3. Replace the felt filter (C).
4. Clean the foam filter (B) with warm soap water.
Note:
An air filter that is used for a long time can
not be fully cleaned. Replace the air filter regularly
and always replace a defective air filter.
Always use the
Technical data
C
11