Aux In Playback; Listening To The Radio - ION Bronco LP Guia De Inicio Rapido

Aux In Playback

1. Set the Source to Aux In.
2. Connect an 1/8" (3.5 mm) stereo audio cable (not included) from the Aux In on the front panel of
Bronco LP to the line output or headphone output of your external audio device to be able to listen to
the external source through Bronco LP's internal speakers.
3. Adjust the volume on Bronco LP to the desired level.
Note: If the line output of your external device is connected, you only need to adjust the system's volume
control. If your external device's headphone output is connected, you may need to adjust the volume
control on both your external device and Bronco LP to achieve the desired volume.
USB Flash Drive Playback
The following file types are playable from USB flash drives: MP3, WAV, and WMA.
To playback a file:
1. Connect the USB flash drive to the USB port.
2. Set the Source to USB. The unit will start playback.
3. Press the Stop button to stop playing.
Note: Please note that the unit can only read FAT32 format USB flash drives that are 32GB or less.

Listening to the Radio

1. Set the Source to the desired frequency (AM or FM).
2. Select the desired radio station by turning the Tuning dial.
3. Adjust the volume to the desired level.
Note: The receiver has a built-in FM antenna hanging at the rear cabinet. This wire should be fully uncoiled
and extended for best reception.
Recording
Recording from the Turntable
1. Select Phono using the Source button.
2. Insert the USB flash drive into the USB slot.
3. Lower the tonearm to the desired location on the record.
4. Press the Rep/Rec button.
5. During recording, press the Next Track button to create a separate audio file.
6. Press the Stop button to stop recording.
Recording from the Aux Input
1. Insert the USB flash drive into the USB slot.
2. Select Aux In using the Source button.
3. Connect your external audio device and start its playback.
4. Press the Rep/Rec button.
5. During recording, press the Next Track button to create a separate audio file.
6. Press the Stop button to stop recording.
7