CORBERO E-CCHH9100W Manual De Instrucciones página 40

Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician
of competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant
circulation).
Problem
Appliance dose not
work
Appliance freezes too
much
The food is not
frozen enough
Heavy build-up of
frost on the door
seal.
Unusual noises
Possible cause
Mains plug is not plugged in or
is loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or
the appliance runs at "7"
setting.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Door seal is not air-tight.
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, in
the side of the appliance is
touching another part of the
appliance or the wall.
Solution
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to
a warmer setting temporarily.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Please look in the installation
location section.
Carefully warm the leaking sections
of the door seal with a hair dryer
(on a cool setting). At the same
time shape the warmed door seal
by hand such that it sits correctly.
Check the appliance and level it by
some articles.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
17