Installation Notes; Troubleshooting - Klarstein BEERSAFE Manual Del Usuario

INSTALLATION NOTES

It is important that upon receipt you stand your appliance upright for at least 4 hours
before switching on to allow the system to sett le.
• The appliance should not be tilted more than 45 degrees when you move it. Do not
use force on any part such as the condenser, the door or handle. They could distort
and affect the operation of the cooler. Ensure ALL packaging is removed before
installation.
• Make sure there is enough ventilation space around product.
• The appliance should not be installed near external heat sources eg direct sun shine
or external moisture sources.
• Ensure the supply voltage of socket is same as rating label. 5 . The plug must be
properly inserted to the wall socket.
• The mains supply socket must be earthed - preferably with a switch. If it is not
earthed, do NOT install this appliance there. Do not use an extension cord.
• The product is equipped with adjustable feet. Once the product is in place, adjust
these to ensure the fridge is level and doesn't rock.
Note: Do not site the product where the ambient temperature is likely to drop below
5 °C - eg: garage or shed.

TROUBLESHOOTING

Problem
Condensation on outside of
door.
Condensation on the inside
of the cabinet.
Too cold / not cold enough
inside the cabinet.
No power to cooler.
Possible cause and suggested solution
Humidity in the room is high. This is also to be
expected if the room is very warm.
This is also caused by high humidity. You can
minimise this by only keeping the door open only as
long as you need to.
Adjust thermostat up or down accord ingly. Make
sure nothing is stopping the door from sealing
properly.
Check power cor d, power supply or on/off switch.
EN
19