How To Wire Your Ceiling Fan - Fanimation EDGEWOOD FP9072 Serie Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

How to Hang Your Ceiling Fan (Continued)

For Close-to-Ceiling Fan

Securely attach the hanger bracket to ceiling fan

outlet box using the outlet box screws and washers

supplied with the fan. (Figure 6)

Using the 3/8˝ x 2˝ lag bolt and flat washer, attach

safety cable to ceiling joist or wood structural member.

The lag bolt will pass through the flat washer, safety

cable loop, and into the building structure (Figure 6).

You will first drill a 1/4˝ pilot hole into the building

structure to prevent splitting or cracking.

NOTE: Ceiling support cable cannot be secured to

outlet box only, it must be directly secured to ceiling

joist or structural member using the 3/8˝ x 2˝ lag bolt

and flat washer. (Figure 6)

Hook the motor assembly onto the hanger bracket

assembly as shown (Figure 7).

10.

Attach the safety cable to ceiling support cable.

Slide cable clamp onto safety cable (from fan). Place

the end of cable through the loop of ceiling support

cable. Pull as much cable through loop as possible.

Feed end of cable into clamp hole and firmly tighten

screw (Figure 8). Cut off excess safety cable. You can

now proceed with the electrical wiring of your fan.

WARNING

To avoid possible electrical shock, be sure electricity

is turned off at the main fuse box before wiring.

(Figure 1)

Connect the green grounding lead from the hanger

ball and the green grounding lead from the hanger

bracket to the supply grounding conductor (this may

be a bare wire or wire with green colored insulation).

Securely connect wires with wire connectors supplied.

(Figure 2)

Securely connect the white fan motor wire to the

white supply (neutral) wire using wire connector

supplied. Securely connect the black fan motor wire

and blue wire to the black supply wire using wire

connector supplied. (Figure 2)