Operation Instructions; Maintenance; Technical Data - Surtek RP542A Manual De Usuario

After the machine is
assembled, adjust the
bolt A to press against
the side of the col-
lector body (B), then
tighten the nut C.

OPERATION INSTRUCTIONS

The RP542A dust collector can be used to vac-
uum-up waste (chips, shavings, etc) after plan-
ing, milling and sawing.
IMPORTANT: Do not suck metal pieces,
large blocks of wood or pieces of batten into
the collector. Use only accessories designed for
the RP542A. It is more efficient to use the fil-
ter cartridge than the dust bag to collect wood
chips.
• Do not use the RP642 for ink or paint spray,
or explosive substances such as gases or pow-
ders.
• Do not use the RP642 for ink or paint spray,
or explosive substances such as gases or pow-
ders.
•The collection container should be emptied as
required, but at least after each use.
1. Conect hose to the
vacuum port on the
dust collector.
2. Connect to the ma-
chine on use to collect
the waste.
NOTE: The filtering bag should be cleaned
each time the dust bag is changed.

MAINTENANCE

• The dust collector should be cleaned each
time the collection bag is changed.
• Damaged filters and bags must be replaced
immediately in order to minimize dust disper-
sion in the work area.
E N G L I S H •
MOTOR
Excessive dust can cause the engine to over-
heat. Each effort should be made to prevent
foreign matter from entering the engine.
When operating under conditions that allow
the accumulation of dust, dirt or debris inside
the engine, you must perform a visual inspec-
tion at frequent intervals. Accumulations of
dry powder can usually shut off the engine.
Use a low pressure hose air.
NOTE: Engines used in woodworking tools are
particularly susceptible to the accumulation of
dust and pieces of wood and must be removed
or emptied frequently to prevent interference
with motor ventilation.

TECHNICAL DATA

VOLTAGE-FREQUENCY
INLET DIAMETER
BAG DIMENSIONS
SUCTION POWER
SUCTION FLOW
POWER
AMPERAGE
ROTATION SPEED
WEIGHT
U se r ' s m an ua l
120 V ~ 60 Hz
1 x 4" (101,6 mm)
14,5" x 25,2" (37 cm x 64 cm)
607 Pa
500 CFM (14,15 m²/min)
1 HP
4,5 A
3 400 r/min
27 kg (59,5 lb)
11