Purpose Of Use; Work Area Safety - Beta 1945C Manual De Uso E Instrucciones

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS FOR PNEUMATIC STAPLER/NAILER, COMBO
TOOL, MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
CAUTION
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING
THE PNEUMATIC TOOL. FAILURE TO COMPLY WITH THE SAFETY
STANDARDS AND OPERATING INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY.
Store the safety instructions with care and hand them over to the users.

PURPOSE OF USE

- The pneumatic stapler/nailer, combo tool, can be used for the following purposes:
• Driving metal pins onto wood frames and cases, fixing skirting boards etc.
• For fixing parts, including staples and nails
• The pneumatic stapler can also be used in open places exposed to water and air
- The pneumatic tool must not be used for the following operations:
• The pneumatic tool must not be used in environments containing potentially explosive atmospheres.
• The trigger must not be locked with adhesive tape or clamps.
• The security stylus may not be removed.
• The pneumatic tool must not be used for any applications other than stated ones.

WORK AREA SAFETY

- Beware of both surfaces that may become slippery due to the use of the machine and the danger of tripping over the air hose.
The fixing parts may pass through thin machined parts or come out of corners or edges of machined parts, thereby posing
hazards to people.
Do not use oxygen or combustible gases as sources of energy.
Do not operate the pneumatic tool in environments containing potentially explosive atmospheres, because sparks may be
generated, which can ignite the dust, fumes or gases.
Avoid contact with live equipment: the pneumatic tool is not insulated, and contact with live parts can cause electric shocks.
Keep children and bystanders away from your workplace while operating the pneumatic tool. Distractions from other
people can cause you to lose control over the pneumatic tool.
PNEUMATIC TOOL SAFETY
Do not point the pneumatic tool to yourself or other people.
Handle the pneumatic tool in the workplace by only using the handle, without enabling the trigger.
Do not operate the pneumatic tool when loadless, to avoid hazards from free fixing parts and prevent the tool from being
overstressed.
- Do not point the air flow to yourself or other people. Compressed air can cause serious injury.
- Check the connections and the air supply lines. All units, couplers and hoses should conform to the product specifications in
terms of pressure and air volume. Too low pressure impairs the function of the pneumatic tool; too high pressure can cause
damage and/or injury.
- Do not bend or tighten any hoses; avoid using solvents and sharp edges. Keep the hoses away from heat, oil and rotating parts.
Immediately replace any damaged hose. A defective feed pipe may cause uncontrolled movements of the compressed air pipe.
Raised dust or chips may cause eye injury. Make sure that the hose clamps are always secured firmly.
EN I
9