Velleman 3DPEN1 Manual Del Usuario página 5

4. Features
• can be driven by power bank, connection to AC/DC adapter not
needed
• double click loading/unloading button to fill and remove filament
automatically
• super slim design
5. Overview
Refer to the illustrations on page 2 of this manual.
1 power input
2 wire-feeding hole
3
temperature controller
4
heating LED
5 power LED
6. Operation
1. Insert the power plug from the adapter into the power input [1].
Connect the adapter to the mains. The red power LED [5] will
light; the pen is in standby mode.
2. Press the wire-feeding button [7] once. The heating LED [4] will
flash to indicate the pen is preheating.
3. Leave the pen to preheat for about 1 minute or until the heating
LED [4] turns green.
4. Insert the filament through the wire-feeding hole [1] and hold
the wire-feeding button [7] pressed to load it into the pen. Wait
for molten filament to come out of the nozzle [8].
5. The pen is now ready for use. Adjust the feeding speed with the
speed controller [4] if necessary.
6. When done drawing, hold the wire-unloading button [6] pressed
to unload the filament out of the pen. Next, hold the wire-
feeding button [7] pressed to extrude molten filament rests and
to clean the inside of the nozzle [8]. Disconnect the pen from
the mains and leave it to cool down before storing.
V. 02 – 09/05/2016
3DPEN1
6
7
8
9
5
wire-unloading button
wire-feeding button
heating nozzle
speed controller
©Velleman nv