SUHNER ABRASIVE TURBO TRIM SHS 500 Documentación Técnica página 27

the above instructions in reverse order. After connecting,
press the grease cup button two to three times.
4.1.2 Regrinding the blade
The blade can be reground with a com-
mercially available grinding machine.
There are special adapter plates available
for SUHNER blades.
Very sharp blade!
4.1.3 Hardening the blade
resentative or directly from the manufacturer. Apply the
steel under a light pressure. The last pass should be
along the inside of the blade. When cutting does not im-
prove, the blade must be replaced. Contact the area rep-
resentative or the manufacturer for further information.
Outside edge / Inside edge
There must be an adequate distance between the blade
and the steel.
Very sharp blade!
Exclusively SUHNER steel
must be used. This can be
purchased from the area rep-
4.1.4 Honing the blade
Before honing, clean the hand
piece of all fat and meat residue.
The blade must be honed every day with a knife sharp-
ener or a stone.
With the motor running, hold the flat side of the whetstone
against the flat side of the blade. Move the whetstone
back and forth.
4.1.5 Greasing the blade
Use only food grade (FDA ap-
proved) lubricants, e.g. TURBO
LUBE
60000078), TURBO LUBE SPRAY (art. no. 60000077).
To fill the grease cup, press in the button. Insert the grease
gun into the nipple on the grease cup, and press strongly
to charge it with grease. Stop when the button has moved
up. Press the grease button at regular intervals and after
cleaning and connecting the hand piece.
GREASE (art. no.
27