Publicidad
Idiomas disponibles
Idiomas disponibles
Attention items
1.lt can't be used in places where the sun shines directly,the temperature is high(over)or low(below)high
humidity,high dust or seriously shaken.
2.lt should avoid being stricken when you add a heavy object to the platform.
3.When overloaded,it indicates"-OF-" and alarms "toot",and you should reduce the heavy object on the
platform.
4.lt can work within the regular voltage:voltage(too high or too low) can cause loss.
5.lf the plug is still on the power supply,the scale is Electrified even the switch is "off". please pull out the
plug when it is not used for a ling time.
6.Avoid cleaning the surface with strong solvent such as benzene, acetone and so on, otherwise, the
surface will be badly damaged.
7.Clean the dirty platform and the outer covering with dry cloth.Don't splash water, otherwise the water
will enter the scale to cause short circuit.
8.Please keep the body of the scale clean.
9.lt can switch off automatically when battery – powered is low.
Battery recharging
1.During the 1 st use and future use,the unit is required to be recharged for 20 hours continuously, after
the battery is fully charged, the unit can work about 25 hours of continous use (or 40 hours of
discontinous use)
2.lf the low battery indicator is automatically switched on,we need to repeat the above recharging
immediately, otherwise, the unit will be easily not working because of very low battery power inside.
Installation steps:
1.Place the scale on the firm and flat table after opening.Put the four white dustproof rings on to the four
rubber feet,and then place it on the plate.
2.Use the four feet to adjust the level until the level sponge is in the center.Meanwhile make sure that
the four feet are on the platform,otherwise is can affect the weigh accuracy.
3.lf the power circuit is not in ground connection,you can connect the ground wirewith the grounding.
4.Connect one end of the power circuit to the scale,and the other end to the socket.Don'tconnect
the samewire with high-power equipment,for the high-power equipment can affect weigh when i
lt works.
5.When there is nothing heawy on the platform,turn on the switch,all the indicators glitter and all
The indicating windows are zeros.When necessary,you can put a certain special purpose scale
Or packing materials on the scale,which can improve the weigh accuracy.Press"TARE"key to
Indicate zero if the heavy object exceeds the weight limit.
6.With kg and pound system, can select either kgs or lbs by the exchange button "kg/lb", it shows kg
when the light of "KG/LB" is off, shows lbs when the light of "KG/LB" is on.
Procedure for Decimal Setting
1. Decimal to no decimal (Unit Price and total Price Windows show "0"): 158 - Tare - 5 - Tare
2. No decimal to decimal ((Unit Price and total Price Windows show "0"): 158 - Tare - 25 - Tare
Página 4
Publicidad
