Attention!
Do not remove the float from the
reservoir. No full reservoir signal will
then be given and water will be able to
leak out of the tank.
If the reservoir is dirty, clean it with cold
or lukewarm water. Don't ever use
volatile
chemicals,
gasoline, detergents, chemically treated
clothes, or other cleansing solutions.
This can damage the tank and cause
leaks.
Continuous drainage
When the dehumidifier is operated at very high humidity levels, the water tank will
require more frequent drainage. In this situation, it may be more convenient to set
the unit up for continuous drainage with the following procedures:
1. Pull out the water tank.
2. Connect an appropriate tube (gardenhose or something like that) with a clamp
on the drain pipe. Please note: the
water tube is not supplied with the
unit.
3. Put the water tank back to its
position and lead the tube through
the opening for continuous drainage
down into a drain or a big container.
Please note: in case, the water
tank has not been positioned well,
the water full indicator will turn into
red. The equipment does not work
4. Ensure the water will always drain away freely and the tube will remain in right
place. Note! In very cold weather conditions, precautions should be taken to
prevent the water tube from freezing.
Thawing
If the appliance is operating at a low temperature, the evaporator can freeze. This
will influence dehumidification. In that case the operation of the appliance will be
automatically interrupted and it will start to thaw (the fan will continue turning).
(DryBest 10: the "defrost" lamp will light up, DryBest 20 does not have a lamp, but
does thaw automatically.
Protection of the compressor
If you have switched the appliance off (or if it has switched itself off), then it cannot
be switched on again for 3 minutes, this is to protect the compressor.
scouring
pads,
21