Boiling Water; Boil-Dry Protection - Koenic KWK 4331 W Manual De Instrucciones

Size - A5
English

Boiling water

Connect the power plug to a suitable
Fig.
1
power outlet.
Fig. Press the lid release button to open
2
the lid.
Fig. Fill the kettle with water to the desired
3
level.
Do not exceed the MAX level (1.70L).
Fig.
4
Consider the minimum filling quantities
(Min. 0.75L).
Fig. Close the lid until it clicks into place.
5
Place the kettle on the stand.
Press down the ON/OFF lever to turn
Fig.
6
on the kettle. The indicator lights on.
The kettle will switch off automatically,
Fig.
7
once the water has boiled. Wait 15-20
seconds before operating again. The
approximate temperature is indicated
by the thermometer.
Fig. Unplug the power plug from the power
8
outlet.
Caution
Do not open the lid when steam is emitted
from the spout.
Note:

Boil-dry protection

Never turn on the product when it is empty.
If the unfilled water kettle is switched
on accidentally, the boil-dry protection
automatically shuts off the product. In this
case, wait 15 minutes before filling with
water again to allow the product to cool
down.
14
IM_KWK4331W_181010_V02_HR.indb 14
Cleaning and care
Warning
• Unplug the product and let it cool down
completely before cleaning. Never
immerse electrical parts of the product
in water during cleaning or operation.
Never hold the product under running
water (except when filling the kettle, see
chapter Boiling water).
• When cleaning, never use solvents or
abrasive materials, hard brushes, metallic
or sharp objects. Solvents are harmful to
human health and can attack plastic parts,
while abrasive cleaning mechanisms and
tools may scratch the surface(s).
Clean the product's exterior surfaces
Fig.
9
with a slightly damp cloth and then dry
them thoroughly.
Make sure that no water enters the
device interior (for example, through
the switch) or the base.
Descaling
• Descale your product regularly depending
on your water's lime content and frequency
of use.
• Use an off-the-shelf decalcifier and follow
the provided instructions.
• As an alternative, you can descale your
product with a vinegar solution:
1. Pour 30 ml of white wine vinegar into
the kettle and fill the kettle half-full with
water.
2. Boil the solution and let it soak for a
minute. Repeat this process three times.
3. Pour the solution down the drain and
rinse the kettle thoroughly with water.
4. Fill the kettle with fresh, clean water.
Bring to a boil and pour this water down
the drain. To get rid of the smell of
vinegar, repeat this step several times.
11/10/18 11:43 am