Changing The Video Signal Of The Mcs1 - Sony MCS1 Manual De Instrucciones

Changing the Video Signal of the MCS1

You can change the video signal used by the MCS1. You can choose
between NTSC and PAL.
Note
Perform this setup procedure while there are no CD-R or other media inserted in the
MCS1. If a CD-R or other media is inserted, the procedure below does not work.
1
Hold down the POWER button for at least 2 seconds to turn
the MCS1 on.
2
Press and hold the MODE button for at least 2 seconds.
The following indication appears in the display window.
3
If you want to change the video signal, use the T/t
buttons to move the cursor to "NTSC" or "PAL".
4
Press the ENTER button.
The video signal is changed.
z
Hints
• The video signal that appears in the display window is the one currently in use.
• The default setting is NTSC.
• Below are some examples of regions that use these video signals.
NTSC: U.S.A., Japan, etc.
PAL: Europe, etc.
GB
27