Guidelines For Treatment; Average Treatment Time - Philips Lumea Precision Plus SC2008 Manual De Instrucciones

Tabla de contenido

Area

Underarms

Bikini line

Entire bikini area

One lower leg

One full leg

Upper lip/ chin/ sideburns

Press the flash button to release a flash. Now you have 2 options to

release the next flash:

A Keep the flash button pressed. The appliance releases one flash

after another as long as the safety ring is in full contact with the skin.

Immediately after the appliance has flashed, slide the appliance to the

next area. Make sure the safety ring is fully pressed onto the skin.

This 'Slide & Flash mode' is especially convenient for treatment of larger

areas like the legs.

B Let go of the flash button after each flash. For the next flash, place the

appliance on the area right next to the previously flashed area. Make

sure the safety ring is fully pressed onto the skin.

This 'Step & Flash mode' guarantees a precise treatment of e.g. the upper

lip, knees or ankles.

Note: After a few seconds, the appliance is ready to flash again, so make sure

that you move it to the next area immediately after it has flashed.

Do not treat exactly the same area multiple times during one session.

This does not improve the effectiveness of the treatment, but increases

the risk of skin reactions.

Note: The visible light produced by the appliance is the reflection of the flash on the

skin and is harmless to your eyes. It is not necessary to wear goggles during use.

To avoid untreated areas, always make sure there is a slight overlap

with the previously treated area when you place the appliance on the

skin. The effective light only comes out of the light exit window. Make

sure the flashes are produced close to each other.

Switch off the appliance after you have finished the treatment.

Check the light exit window and the attachment for hairs and dirt and

clean the appliance after use (see chapter 'Cleaning and maintenance').