jbc RMSE-C Serie Manual De Usuario página 7

Operation with JT station
1. Placing 2. Heating
Position the extractor with the Heat the component.
appropriate suction cup and
press the suction button.
Process Control
Manual Mode
Time to stop
T e m p
400 85
Current temperature
400 º C Select
Selected temperature
Power
Access Menu (pess key 2 seconds) & Confirm Selection
You can switch between operating modes (Manual Mode / Program Mode) by pressing the
"increase" and "decrease" keys simultaneously for 2 seconds (Only when programs mode is ON).
12
3. Releasing
The component lifts off
automatically when the
solder melts.
45 seconds
º
C
A i r %
Current air flow
70%
% Instant power supplied
to heater
Program Mode
P r o g r a m 8
º C
Graph of selected
program
Decrease program
number
Program Options
Edit Program
This option allows you to edit or create a program.
First, you must select the program to edit and then modify the points that make up the program.
Each program is composed of 9 points, each point consisting of 3 parameters:
1. Time (seconds)
2. Temperature (°C / °F)
3. Flow rate (%)
You can delete the last point of the program by selecting "-----" in the time parameter.
It should be taken into account that the regulation range permitted by the station is 150-450°C, whe-
reby it is not possible to create temperature ramps between room temperature (Toff) and 150°C.
The station can store up to 25 temperature programs.
The first three programs are edited by JBC as an example.
Copy Program
This option allows you to copy a program.
You must select the program source and its destination (where it will be copied).
Delete Program
This option will allow you to delete a previously selected program.
w w w.jbctools.com
Selected program
T e m p º C
380
Current temperature
Air 100%
Selected air flow
Time 125s.
Remaining time
Increase program
number
13