Warm Milk; How To Turn Off The Unit; Care And Cleaning Instructions; Maintenance - Mr Coffee BVMC-MF Serie Manual Del Usuario

4. Your milk is ready to use to create refreshing and
delicious iced cappuccinos and more!
5. Remove frothing cup from power base, pour, spoon and
enjoy!

Warm Milk

After setting up the appliance and adding fresh cold milk
follow these steps:
1. Press "SELECT" until LED light is on Warm Milk cycle.
(Figure 4)
2. Then press the On/Off button ( ) to start the selected
cycle. (Figure 5)
3. When cycle is completed the ON/OFF LED will go OFF
and the selected function LED will stay ON.
4. Your milk is ready to use to create delicious drinks or
desserts!
5. Remove frothing cup from power base, pour and enjoy!
Frothing Disk Storage
For convenience the unit has storage built-in underneath the
power base.

How to TURN OFF THE UNIT

1. To turn off the unit simply press and hold on/off ( ) until
light goes off.
2. When you remove the appliance from the base, the
temperature setting and heat retention function are reset.
-10-

Care And Cleaning Instructions

Cleaning Your Frothing Cup
1. Always make sure your Milk Frother is unplugged before
cleaning.
CAUTION: Allow to cool before putting on or taking off
parts and before cleaning the appliance.
2. Remove the frothing and heating disk from the frothing
cup.
CAUTION: CHOKING HAZARD - Small parts. Not for
children. Use with adult supervision only.
3. Wash the frothing cup, lid and disk with mild detergent
and water. You may also wash them in your dishwasher.
4. Discoloration of the heating plate may occur if milk spills.
Scrub lightly with baking soda.
5. The outside of the frothing cup can be wiped with a soft
damp cloth.
CAUTION: Do not immerse power base in water or
other liquid.
Note: Never use any chemical, steel wool, or abrasive
cleaners to clean any part of the milk frother, including the
power base.

MAINTENANCE

This appliance has no user serviceable parts beyond the care
and cleaning described in the Care and Cleaning section. Any
other servicing should be performed only by an authorized
service representative.
-11-