Pur Line CHE-610 Manual De Usuario página 14

Heater
Press the heat button to turn on and off the heater.
When the heater is turned on, press and hold the heat button for 5 seconds to enter temperature adjustment
mode. The LED indicator is red, the display will flash. There are 22 levels to change Fahrenheit temperature (ON,
62°F - 82°F). After this is set, the display will flash 5 times and exit from setting status.
To switch from Fahrenheit to Celsius degrees, press and hold the power button for 5 seconds. The LED indicator
will turn to green. There are 12 levels to change Celsius temperature (ON, 17°C - 27°C). Repeat the same process
to convert Celsius to Fahrenheit.
NOTE: Degree Fahrenheit will be displayed in RED and degree Celsius will be displayed in Green.
Timer
Press the timer button to turn the timer on. The timer function can controls both the flame effect and heater.
Button Press Timer interval
1st Press 30 minutes
2nd Press 1 Hour
3rd Press 2 Hours
4th Press 3 Hours
5th Press 4 Hours
6th Press 5 Hours
7th Press 6 Hours
8th Press OFF
Week timer
Note: to set up time when to turn on and off the unit and thermostat for max. 7 days, 0 - 3 groups available for
each day.
On control panel: Press and hold the timer button on control panel for 5 seconds until the digital display shows
"1d", and press again until digital display shows "--", to start the timer setting of group #1 press flame button
or heat button, and re-press the timer button again to confirm the TURN-OFF setting. To continue to setup the
temperature of group #1 press flame button or heat button, and re-press the timer button 3rd time to confirm
and continue to setup group #2, group #3 of 1st day and repeat it for next 6 days. Note: stop pressing any of
those buttons for more than 5 seconds, will quit the week timer function and confirm the previous setting.
With remote control: Press the week timer button 1st time to activate the function and display will show "1d",
press 2nd time to enter the adjustment mode, then press the week timer adjustment buttons +/- to setup the
time to turn on and turn off the unit, and press the week button 3rd time to setup the temperature. Repeat to
setup the time and temperature for other groups and different days. Note: stop pressing any of those buttons
for more than 5 seconds, will quit the week timer function and confirm the previous setting.
lnstall / Replace Battery of remote control
The remote control is provided with a CR2025 battery. Remove the plastic insulating sheet before using.
To replace or remove old battery, push in the clip and pull the battery bracket out simultaneously.
lnsert a new battery with the button side into the battery bracket, make sure the battery is firmly seated.
To replace the bracket, simply push it into the remote contro!. Make sure the bracket snaps into position.
NOTE: Remove battery from remote control if not use for an extended period of time.
CAUTION! WARNING: Dispose old / used battery at a suitable recycling point or
according to locai regulations.
CAUTION! WARNING: DO NOT ingest battery. lf accidentally swallowed, seek for
medical help immediately.
EN
Display
30
1h
2h
NOTE: Timer only controls heater if only the
heater is on before timer is set.
3h
NOTE: Timer only controls flame effect
4h
function if only the flame effect function is
on before timer is set.
5h
NOTE: Timer can control both heater and
6h
flame effect function if both are on before
timer is set.
None
12