BaByliss PRO Nano Titanium MiraCurl Steam Tech BABNTMC2 Manual Del Usuario página 4

OPERATING INSTRUCTIONS
the miracurl ® steam tech will create many different curl effects in the hair. it is easy to
experiment with the different settings to achieve your desired results.
always ensure that the sections of hair you want to curl are no wider than 1 inch wide.
the type of curl will depend on the temperature selected and the timer setting, which
dictates the amount of time the hair is kept inside the curl chamber.
TEMPERATURE SETTINGS
there are 3 temperature settings to select from 375°F, 410°F and 450°F. We recommend
you always start with the lowest temperature setting and increase the level of heat as
required.
• Setting I (375°F) - for delicate, fine or colored hair
• Setting II (410°F) - for normal textured hair
• Setting III (450°F) - for thick or wavy hair
TIME SETTINGS
there are 3 time settings with an automatic beep indicator. these different settings will
give different curl effects. the longer the hair is held inside the curl chamber, the more
defined the curl will be. but results will also vary according to hair type. use the following
as a guide:
• Setting 8 (8 seconds = 3 beeps) - for loose waves
• Setting 10 (10 seconds = 4 beeps) - for soft curls
• Setting 12 (12 seconds = 5 beeps) - for more defined curls
• At the end, there will be 4 quick beeps in succession to indicate time is up, and it's ready
to release hair.
STEAM FUNCTION:
• Fill reservoir as described in "Filling the Water reservoir" below
• Turn the machine on and allow to heat (red light will stop blinking) before turning on
the steam function. steam function is not recommended if the red light is still blinking
• Slide the steam On/Off switch to ON
• If not using steam, make sure switch is set to OFF
BABNTMC2 IB-126966.indd 7-8
FILLING ThE wATER RESERvOIR:
• To remove the water reservoir, lift the edge up slightly then pull
it out of the unit
• Open the black rubber cap in back of reservoir and fill with
distilled water
• Put the rubber cap back on, making sure it's completely sealed
• Lock reservoir back onto the unit (you should hear a "click")
• For your safety, turn the machine off when removing, filling or installing the water
reservoir back onto the unit
AUDIO OFF SETTING
you can turn off the automatic beep indicator if it is not required by sliding the timer
switch to 0.
NOTE: When the 0 setting is selected, there will be no beep indicator to advise when to
release the styler. take extra care when using this setting.
CURL DIRECTION SETTING (Right/Left/Alternate)
use the curl direction control to choose either a uniform or natural finish. select the curl
direction by sliding the switch to either left (l) or right (r) or alternate (a).
(l) starts the curl to the left, counterclockwise.
(r) starts the curl to the right, clockwise.
you can also select the opposite direction on each side to create a symmetrical look.
When styling the left side of the hair, slide the curl direction switch to the left position (l).
When styling the right side of the hair, slide the switch to the right position (r). this ensures
that the curl sits toward the face on both sides of the head and will give a more uniform style.
For a more natural look, select the alternate setting (a). this will alternate the direction
after each curl.
1
2
removable water reservoir
(Fill with distilled water only)
7/29/14 9:33 AM