Fuel Tap; Spark Plug - Ferm PGM1009 Traducción Del Manual Original

element and gently squeeze out any excess
oil.
• Replace the filter element and air filter
cover.
• Be sure the filter cover seals properly all
around.
Do not run the engine without the air
filter element in place.
Never place a wet filter (with solvent)
on the machine.

Fuel tap

• To remove the fuel tap filter, simply undo
the cup at the bottom of the fuel tank.
• Use a small spanner to remove the tap.
• Clean and wash out the filter and cup, and
replace.
Troubleshooting
Basic checks
• Make sure you have plenty of fuel
• Make sure the fuel tap is on
• Make sure the engine-switch is on
• Remove spark plug, connect spark plug
lead and earth it to the generator. Pull
starter cord gently and look for a spark. If
there is no spark, replace spark plug.
Spark plug is OK, but engine still won't start
• Check fuel tap filter is clean
• Check fuel line is clear
• Check carburetor is not clogged
Engine will not start
• Clean or replace spark plug
• Check ignition system – if faulty, contact
your service centre
• Check compression – if low, contact your
service centre
• Check for loose cylinder head – tighten
bolts
• Check for damaged cylinder head gasket –
replace if necessary
Cleaning
Clean the housing regularly with a soft cloth,
preferably every time it is used. Keep the air
vents free of dust and dirt.
Remove stubborn dirt with a soft rag moistened
in soapy water. Do not use any solvents such
as petrol, alcohol, ammonia, etc. as such
Ferm
substances can damage the plastic parts.
Storage (long term)
• Drain fuel tank, fuel tap, carburetor bowl
and carburetor
• Pour 1 cup of engine oil into the fuel tank
and shake the generator to spread the oil
around the tank. Drain excess oil.
• Remove spark plug and pour in 1 spoonful
of engine oil, pull the starter cord several
times with the starter switch OFF. Replace

spark plug.

• Pull on the starter cord until you feel
compression and stop.
• Clean the generators exterior and coat with
rust inhibitor.
• Place the generator on flat ground and
cover with a clean dry cloth.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you
find an exploded view showing the parts that
can be ordered.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging
which consists largely of reusable material.
Therefore please make use of options for
recycling the packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be
collected at the appropriate recycling
locations.
Warranty
Read the terms of warranty on the separate
warranty card which is enclosed.
GB
7