Mounting The Mains Rectifier; Using The Mains Rectifier - Dometic COOLPOWER MPS 80 Instrucciones De Montaje

Mounting the mains rectifier

6 Mounting the mains rectifier
If you wish to mount the mains rectifier in a fixed position, please observe the
following mounting instructions:
• Do not mount the device
– In wet or damp environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions
• The place of installation must be well-ventilated. A ventilation system which is at
least equivalent to the air openings in the device must be present for installations
in closed housings.
• The air intake on the underside or the air outlet on the back of the device must
remain clear.
• The installation surface must be level and sufficiently sturdy.
➤ Secure the mains rectifier with screws through the fastening holes at the front and
the back of the device (fig. 1 2, page 3).
7

Using the mains rectifier

A
NOTICE!
• Do not reverse the polarity. If the poles are reversed device may
overheat and be damaged.
• Replace defective fuses with new ones of the same rating (25 A).
To avoid drops in voltage and therefore performance, keep the cable route as short
as possible and only disconnect it when necessary.
The cables between mains rectifier and compressor must not exceed 1 m and must
have a cross section of at least 2.5 mm²!
➤ Fit wire sleeves to the ends of wires which you wish to connect to the mains
rectifier.
➤ Ensure that the battery's positive supply line is secured with a fuse (fig. 2 1,
page 3) of the following value:
– at 12 Vg: 20 A
– at 24 Vg: 10 A
The fuse must be installed as close to the battery as possible.
➤ Connect the battery using the B+ and B– connection terminals (fig. 3, page 3).
➤ Connect the compressor using the C+ and C– terminals (fig. 4, page 3).
10
MPS80
EN