Special Wash Cycle And Options - Indesit DFG 26B10 Manual De Instrucciones

Special wash cycles
and Options
Notes:
EN
Optimum performance levels when using the ""Rapid" cycle
can be achieved by respecting the specified number of place
settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
assistenza_en_lvs@indesitcompany.com
Wash options*
The OPTIONS may only be set, changed or reset after the
wash cycle has been selected and before the Start/Pause
button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
corresponding symbol/LED flashes rapidly 3 times.
If an option is selected which is not compatible with another
previously-selected option, it will flash 3 times and go off,
while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
*
Only available in selected models.
18
(see Table of wash cycles)
, the
Half load
If there are not many dishes to be washed, a half
load cycle may be used in order to save water, electricity and
detergent. Select the wash cycle and press the HALF LOAD
button; the indicator light will go on.
Press the HALF LOAD button again to deselect this option.
Remember to halve the amount of detergent.
Delayed start
It is possible to delay the start time of the wash cycle
by 3, 6 or 9 hours:
1:After selecting the desired wash cycle and any other
options, press the DELAYED START button. the indicator
light will go on.
2: Select the desired delay time by pressing the Delayed
Start button repeatedly. The wash phase (3 hours), drying
phase (6 hours) and end (9 hours) indicator lights will go on
in succession.
If the Delayed Start button is pressed again, the option is
deselected and the indicator light goes off.
3. After the selection process, the countdown will begin if
the Start/Pause button is pressed. The selected delay-period
indicator light flashes and the Start/Pause button stops
flashing (fixed light).
3. Once this time has elapsed, the DELAYED START indicator
light goes off and the wash cycle begins.
The Delayed Start function cannot be set once a wash
cycle has started.