Carbon Brushes - skilsaw SPT70WM Instrucciones De Funcionamiento Y Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SM 2610035801 08-14_SPT70WM 8/20/14 8:00 AM Page 16
To avoid accidents always disconnect the tool from the power supply
W RNING
before cleaning or performing any maintenance.
Preventive maintenance
W RNING
performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could
cause
recommend that all tool service be performed
by a Skil Factory Service Center or
Authorized Skil Service Station.
TOOL LUBRICATION
Your Skil tool has been properly lubricated and
is ready to use. However it is recommended
that the gears be relubricated only with Skil
lubricants: No. 80111 (8 oz. tube).
Always check the oil level before using the saw.
To check and add oil: Remove plug from power
source and place the saw's foot on a horizontal
surface with tool set to maximum depth of cut.
Remove oil plug using the same wrench used
to remove the saw blade. The oil level should
never be below bottom threads in the housing.
When adding oil, fill until oil starts to run out of
oil hole at arrow on housing and replace oil plug
(Fig. 15).
NOTE: If oil is dirty or thick, replace the oil plug
and run the saw for one minute to warm up the
oil. Then remove oil plug and turn saw upside
down, to remove all oil. Add fresh Skil lubricant.
With a new saw, change the oil after the first
ten hours of use.
FIG. 17
OIL LEVEL
INSTRUCTIONS
Maintenance
Service
serious
hazard.
OIL PLUG

CARBON BRUSHES

The brushes and commutator in your tool have
been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brushes be examined.
We
The brushes should be free from dust and dirt.
Brushes should be replaced when they have
worn down to 3/16" in length. The brushes
should slide freely in and out of the holders
without sticking.
To check brushes: Disconnect plug from
power source. Unscrew the brush caps on the
motor housing and lift out the brushes; note
which way they face, so that the brushes can
be returned to their original position. To
replace the blade side brush the tool needs to
be set to minimum depth of cut. Clean the
brush holder openings with compressed air or
a clean cloth and replace the brushes and
caps.
Only genuine Skil replacement brushes
specially designed for your tool should be
used.
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating or
motor failure.
The tool may be cleaned most effectively with
compressed dry air. Always wear safety
goggles when cleaning tools with
compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
C UTION
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
-16-
BEARINGS
Cleaning
Certain cleaning agents
and
solvents
damage

Publicidad

Tabla de contenido
loading

Tabla de contenido