Conformity Certificates - Husqvarna FS 410 D Manual De Instrucciones

American National Standards Institute : For units used in the United States, this machine has been
designed to comply with American National Standards Institute ANSI B7.1-2000, "Safety Requirements
for the Use, Care and Protection of Abrasive Wheels". This standard can be purchased by contacting the
American National Standards Institute at the address shown below:
American National Standards Institute
25 West 43rd Street, 4th fl oor
New York, NY 10036
CALIFORNIA AIR RESOURCES BOARD (CARB): This machine is considered a preempt Off-Road
Apllication as relating to CARB standards. Under construction equipment, and in particular, as a concrete
saw (Saws: concrete, masonry, cutoff), with engine power less than 19KW (25 hp), CARB standards
do not apply to this machine.
For more information see the website
EC DECLARATION OF CONFORMITY
Husqvarna AB, SE-433 81 Göteborg, Sweden, tel: +46-31-949000, declares under sole responsibility that the Hus-
qvarna FS 410 D dating from 2010 serial numbers and onwards (the year is clearly stated on the rating plate, followed
by the serial number), complies with the requirements of the COUNCILíS DIRECTIVE:
• of May 17, 2006 "relating to machinery" 2006/42/EC
• of December 15, 2004 "relating to electromagnetic compatibility" 2004/108/EC.
• of May 8, 2000 "relating to the noise emissions in the environment" 2000/14/EC.
The following standards have been applied: EN ISO 12100:2003, EN 55014-1:2006, EN 55014-2/A1:2001,
EN 61000-3-2:2006, EN 61000-3-3/A1/A2:2005, EN 13862/A1:2009.
Huskvarna December 29, 2009
Henric Andersson
Vice President,
Head of Power Cutters and Construction Equipment
(Authorized representative for Husqvarna AB and responsible for technical documentation.)

CONFORMITY CERTIFICATES

Telephone: 212.642.4900
Fax: 212.398.0023
www.ansi.org
http://www.arb.ca.gov/msprog/offroad/preempt.htm