Aiwa TS-WM5 Manual De Instrucciones página 5

OPERATIONS
Power and Volume
Adjust the volume balance between the powered subwoofer
and the left and right speakers of the connected unit.
1 Press the POWER button.
The indicator above the button lights up.
2 Start playback on the connected unit.
3 Adjust the volume of the powered subwoofer.
Moderate volume setting
To get natural bass sounds, adjust the volume of the powered
subwoofer according to its position and the graphic equalizer
setting of the connected unit.
Adjustment examples
a Set the VOLUME control to a little lower than the middle
when the subwoofer is placed on the floor and the
graphic equalizer is set to off.
b Set the VOLUME control to the middle when the subwoofer
is positioned higher than the floor and the graphic
equalizer is set to off.
Notes
•To avoid overloading the powered subwoofer, do not set the
volume of the connected unit so high that the sound is
distorted.
•Low frequency sounds may be distorted when they are
emphasized by the graphic equalizer on the connected unit.
Adjust the VOLUME control on the powered subwoofer or
the graphic equalizer on the connected unit.
•If the powered subwoofer will not be used for a long period
of time, press the POWER button to turn off the power, and
unplug the AC cord from the wall outlet.
•If the output of sound should stop, press the POWER button
to turn off the power, unplug the AC cord from the Wall
outlet, and then in 5 minutes plug it again.
Auto Power
Before using this function, make sure the POWER button is
set to ON.
The power is automatically turned on when receiving a signal
input from INPUT jack.
The power is automatically turned off if no signal is input for
a while and the indicator of the POWER button becomes
dimmer. If input signal is too weak, this function does not
effect.
En
5