Remington DUAL-X F3800 Manual Del Usuario página 4

ENGLISH
F HOW TO USE
SHAVING
• Make sure your shaver is properly charged
• Switch the shaver on.
• Stretch the skin with your free hand so the hairs stand upright
• Hold the shaving head so that the foils touch your face
• Use short, circular strokes.
TRIMMING
• While your shaver is switched on, slide the on/off switch upwards to activate the
trimmer.
• Push the trimmer release button.
• Hold the trimmer at a right angle to your skin
• To retract the trimmer push the top rear of the trimmer downward until it locks under
the trimmer release button.
Tips for best results
E
E nsure your skin is dry. Always hold the shaver at right angles to the skin so that all three
heads are touching the skin with equal pressure.
U se moderate to slow stroking movements. The use of short circular motions in stubborn
areas may obtain a closer shave, especially along the neck and chin line.
D O NOT press hard against the skin in order to avoid damage to the foil.
C CARE FOR YOUR SHAVER
Care for your appliance to ensure a long lasting performance.
We recommend you clean your appliance after each use.
The easiest and the most hygienic way to clean the appliance is by rinsing the appliance head
after use with warm water.
Keep the trimmer in the "off" position when the shaver is not in use.
C CLEANING
Ensure the shaver is switched off and unplugged from the mains outlet.
Open the shaver head by pressing the release button to open the head assembly
Thoroughly blow out the stubble from the foils and cutters.
Tap out excess hair shavings and use a cleaning brush if necessary.
Do not clean the shaving foil with a brush.
Close head assembly.
A CAUTION
Never submerge your shaver completely under water.
4
ENGLISH
TRIMMER
Lubricate the teeth of the trimmer every six months with one drop of sewing machine oil.
REPLACING THE FOILS & CUTTERS
To ensure the continued highest quality performance from your shaver, we recommend that
foils and cutters are replaced regularly.
SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING:
Irritation: As foils get worn, you may experience skin irritation.
Pulling: As the cutters wear, your shave may not feel as close and you may feel your cutter
pulling your hair.
Wear through: You may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL
• Pull the foil assembly up to remove from the hair pocket.
• Insert new foil assembly in hair pocket until it snaps into place.
TO REPLACE THE CUTTERS
• Grasp cutter between thumb and forefinger and pull forward.
• Snap both new cutter assemblies into top of oscillator tips.
Note: DO NOT press on the cutter ends as this may cause damage.
Rotary heads replacement model: SP62
F IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO
PERSONS:
• Do not leave the appliance unattended while plugged in
.• Keep the power plug and cord away from heated surfaces.
• Make sure the power plug and cord do not get wet.
• Do not plug or unplug the appliance with wet hands.
• Do not use the product with a damaged cord. A replacement can be obtained via our
International Service Centres.
Do not twist or kink the cable, and don't wrap it around the appliance.
• Store the product at a temperature between 15°C and 35°C.
• Only use the parts supplied with the appliance.
• The appliance, including its cord, must not be used, played with, cleaned or maintained
by persons under eight years old and should at all times be kept out of their reach.
Use, cleaning or maintenance of the appliance by children over eight or by anyone with
5