Hama uRAGE MIC XSTR3AM REVOLUTION2 Instrucciones De Uso página 7

5. Operation
Note - A Few Tips
• Always position your microphone so that it is as
close to and as directly connected to the audio
source as possible.
• Hold your microphone as still as possible to
prevent interference and wind noise.
• Check the functionality and the transmitted
volume (sound check) before using the
microphone.
• In case of feedback (loud screeching)
immediately switch off the microphone using
the integrated on/off switch. Then eliminate
the cause of the feedback, e.g. by reducing the
volume of the speakers or the input sensitivity
(gain or pad, where applicable) of your
microphone input, and/or moving somewhat
behind your speaker(s) before switching the
microphone back on.
6. Care and Maintenance
• Only clean this product with a slightly damp,
lint-free cloth and do not use aggressive cleaning
agents.
• Wash the pop shield pop-up (if included in the
delivery) only by hand using a mild detergent.
Make sure that the pop-up has completely dried
before use.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
8. Service and Support
Please contact Hama Product Consulting if you have
any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
9. Technical Data
Design
Impedance
Sensitivity
Frequency range
Cable length
Connection
Weight
Condenser / Mono
2200
-45 dB +- 3 dB
20 Hz - 16 kHz
2,5m
USB Type A
ca. 280g/1200g
9