Operation - Defiant MSH27920LWD Guía Del Usuario Y De Mantenimiento

operation

1
Testing the motion sensor
□
Set dial on sensor (B) to "TEST".
□
Turn on the power to fixture. Allow fixture to
warm up approximately 40 seconds before
testing. (Lights may not come on during
warm-up period.)
□
Aim sensor head (B) toward desired detection
area, maintaining a 5°–15° down angle to
allow moisture to drain.
□
Walk across the detection zone at the
farthest distance you wish your detector
to detect motion.
□
Adjust sensor head (B) angle until you get
desired results. Lights will turn off 4 seconds
after all motion stops.
note: For maximum range performance, allow fixture
to operate in any mode (with power to the unit) for at
least 48 hours.
Bottom of sensor
2
Setting the On time
□
Set dial to desired time setting. The higher the
time setting, the longer the lamps will be ON.
(Maximum time is 12 minutes.)
Example of knob arrow placement
to set duration of ON time
B
8
B