5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.
5.2 Use
WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
The device must be completely removed from its packaging. All protections must be completely removed.
Remove the protective sheet from the exterior surfaces. If adhesive deposits form on the device, remove
them using a suitable solvent.
Place the device upright on a solid, flat surface capable of withstanding high temperatures.
Never place the convection oven on a flammable surface. Position this unit so as to ensure optimal air
circulation. We advise you to keep a minimum distance of 15 cm from the wall and other objects.
Do not place any object on the device.
Do not embed the appliance.
Do not install this appliance near open fires, or other heating appliances.
Do not install the device in a wet or humid place.
The electrical cable should be protected to at least 16 amps. The device must be plugged directly into a wall
outlet. Using a multiple socket will cause the device to trip.
Before use, the device must be cleaned.
Before using for the first time, heat the appliance without food.
To do this, plug in the appliance and set your thermostat to 200 ° C and the time to 30 minutes. Do not put
food on until the convection oven has cooled down. Smoke formation and bad odors may occur, this is a
normal operating cycle.
The indicator light comes on as soon as a wheel is operated.
- When the temperature dial is engaged, the indicator lights up then goes out when the temperature is
reached.
- When the cooking time dial is engaged, the indicator light comes on and the fans start to operate.
Place your products on the shelves. When using different plates, use the perforated plates so that the heat
is distributed evenly.
The appliance switches off automatically after the end of the cooking time.
EN