Storage & Service - Tripp-Lite G1010USB El Manual Del Propietario

Basic Operation (Rear Panel)
Coaxial Jacks
Storage & Service
Storage
To avoid battery drain, all connected equipment should be turned off and disconnected from the UPS.
Press and hold the ON/OFF button for one second. Your UPS will be completely turned off (deactivated),
and will be ready for storage. If you plan on storing your UPS for an extended period, fully recharge the
UPS batteries every three months. Plug the UPS into a live AC outlet, turn it on by pressing and holding
the ON/OFF button for one second, and allow the batteries to recharge for 24 hours. If you leave your
UPS batteries discharged for a long period of time, they will suffer a permanent loss of capacity.
Service
A variety of Extended Warranty and On-Site Service Programs are available from Tripp Lite. For more
information on service, visit www.tripplite.com/support. Before returning your product for service, fol-
low these steps:
1. Review the installation and operation procedures in this manual to insure that the service problem does
not originate from a misreading of the instructions.
2. If the problem continues, do not contact or return the product to the dealer. Instead, visit www.tripplite.
com/support.
3. If the problem requires service, visit www.tripplite.com/support and click the Product Returns link.
From here you can request a Returned Material Authorization (RMA) number, which is required for
service. This simple on-line form will ask for your unit's model and serial numbers, along with other
general purchaser information. The RMA number, along with shipping instructions will be emailed to
you. Any damages (direct, indirect, special or consequential) to the product incurred during shipment
to Tripp Lite or an authorized Tripp Lite service center is not covered under warranty. Products
shipped to Tripp Lite or an authorized Tripp Lite service center must have transportation charges
prepaid. Mark the RMA number on the outside of the package. If the product is within its warranty
period, enclose a copy of your sales receipt. Return the product for service using an insured carrier to
the address given to you when you request the RMA.
201011078 93-3003.indd 6
continued
Coaxial Protection Jacks (select models only): Gold-plated coaxial "F"
connectors protect connected equipment by stopping surges on a single DSS
satellite, cable or antenna line. Connect a coaxial cable from the wall jack
directly to the coaxial jack labeled "IN." Connect a coaxial cable from the
coaxial jack labeled "OUT" directly to the device to be protected. The UPS
system must always be the first item connected in line from the coaxial wall
jack. The UPS system must be plugged into a 3-wire grounded AC outlet for
coaxial line surge protection to work. Make sure cables connected to satellite
dishes, antennas, etc. are also grounded. Connecting your equipment to these
jacks is optional. Your UPS will work properly without this connection.
Battery Replacement Door: Under normal conditions, the original
battery in your UPS will last several years. Battery replacement should be
performed only by qualified service personnel. Refer to "Battery
Warnings" in the Safety section. Should your UPS require battery
replacement, visit Tripp Lite on the Web at www.tripplite.com/support/
battery/index.cfm to locate the specific replacement battery for your UPS.
6
11/12/2010 1:57:19 PM