Installation - Dyna-Glo BF10DTL-2 Manual De Instrucciones

INSTALLATION

NOTICE: This heater is intended for use as supplemental heat. Use this heater along with your
primary heating system. Do not install this heater as your primary heat source.
WARNING: A qualified technician must install heater. Follow all local codes.
WARNING: Maintain the minimum clearances. If possible, provide greater clearances from the
floor, ceiling, and adjoining wall than required.
CAUTION: This heater creates warm air currents. These currents move heat to wall surfaces next
to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities
(such as tobacco smoke, candles, cleaning fluids, oil or kerosene lamps, etc.) in the air exist, may
cause walls to discolor.
CLEARANCES TO COMBUSTIBLES
Carefully follow the instructions below. This heater can be mounted on the wall or on the floor
using the support legs (Select models).
WARNING: Maintain the minimum clearances shown in (See Fig. 3). If you can, provide greater
clearances from floor, ceiling, and joining wall.
*LEFT / R IGHT
8 i n.
Top c learance i s f rom t op o f h eater t o c eiling, w ood s helf o r o ther c ombustible m aterial
Bottom c learance i s f rom b ottom o f h eater t o s urface o f c arpet, t ile o r o ther c ombustible m aterial.
*A second side wall must be at least 18 in. away from the other side of the heater.
Always maintain a minimum of 36 in. clearance from furniture and draperies.
*For the installation in residential garages please refer to the bottom of page 3.
Fig. 3 Mounting clearances as viewed
from front of heater (inches)
6 in
Minimum
from side
of heater
LEFT SIDE
36 in. Minimum
from Furniture
and Draperies
FRONT
FLOOR
MINIMUM C LEARANCE T O C OMBUSTIBLES
TOP
36 i n.
CEILING
36 in.
Minimum
RIGHT SIDE
2 in. Minimum to Surface of Carpeting
Tile, or Other Combustible Material
BOTTOM FRONT
3 i n. 36 i n.
10
Rear
0 i n. t o S pacer