Assembly; Adjustments - Bremshey Sport COMFORT CONTROL Manual Del Usuario

NOtE ABOUt SAFEtY
FOR UNItS wItH
ELECtRICAL POwER
Before connecting the equipment to a power
source, make sure that the local voltage
matches that indicated on the type plate:
the equipment operates at either 230 V or
115 V (North American version). NOTE!
The equipment must be connected to a
grounded wall socket. Do not use extension
wires when connecting the equipment to the
power source. Always switch off the power
and unplug the equipment from the electrical
outlet immediately after using!
To reduce the risk of burns, fire, electric
shock or injury to persons:
•
The equipment should never be left
unattended when plugged in. Unplug the
equipment from the outlet when not in use,
before carrying out any maintenance or
repair procedures, and before moving the
unit.
•
Do not operate the equipment under
a blanket or other combustive material.
Excessive heating can occur and cause fire,
electric shock or injury to persons.
•
Do not connect the equipment to a power
source, or operate the equipment if there is
any sort of damage to the power cord or the
unit itself.
•
Do not connect the equipment to a power
source or operate the equipment outdoors or
in damp locations.
•
Keep the power cord away from hot
objects.
•
Do not route the power cord beneath a
carper or place any objects on the cord. Also
make sure that the power cord does not run
underneath the equipment.
•
Do not alter (for example lengthen) the
cord between the transformer and the unit.
NOtE ABOUt
ASSEMBLING tHE
EQUIPMENt
Start by unpacking the equipment. The
detailed assembly instructions can be
found at the back of this guide. Follow the
instructions in given order.
•
O W N E R ' S M A N U A L C A R D I O C O M F O R T C O N T R O L
Before assembly, check the contents of the
package. If a part is missing, please contact
your dealer with the model, equipment serial
no. and spare part no. of the missing part.
You'll find a spare part list at the back of this
guide. The hardware kit contents are marked
with * in the spare parts list. The directions
left, right, front and back are defined as
seen from the exercising position. Keep the
assembly tools, as you may need them e.g.
for adjusting the equipment. Note that two
people are needed for the assembly.
The packaging includes a silicate bag for
absorbing moisture during storage and
transportation. Please dispose of the bag
once you have unpacked the equipment.
Allow at least 100 cm of clearance around
the equipment. We also recommend opening
the package and assembling the product on
a protective base.
SAVE tHIS INStRUCtION MANUAL!

ADJUStMENtS

CORRECt EXERCISE POSItION
In order to find a suitable exercise position, you
can adjust the distance of the seat from the
pedals. Always make sure before beginning
exercising that your exercise position is correct.
1. Place your feet on the pedals.
2. Turn the seat adjustment knob anti-
clockwise and pull the knob outwards so
that the seat can be moved freely.
3. Push the seat to a suitable distance; the ball
of your foot should reach the pedal when
your leg is almost fully extended and when
the pedal is at its furthermost position from
the seat. Check the suitability of the distance
by pedalling anti-clockwise.
4. Release the knob when the distance is
correct; the seat will click into position.
5. Tighten the locking knob by turning it
clockwise.
You can select the inclination of the backrest to
uit your own preferences as follows:
1. Go behind the equipment.
2. Pull the backrest inclination adjustment
knob outwards so that the backrest can be
moved freely.
3. Select the desired inclination.
4. Release the knob when the inclination is
correct; the backrest will click into position.
G B
3