Operation; Cleaning And Maintenance - EuroLite Neon Stick Manual Del Usuario

installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and or
damage to property.
The device has to be installed out of the reach of people.
The device must never be fixed swinging freely in the room.
Caution: Devices in hanging installations may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the device!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
The device must be installed in an absolutely horizontal position.
Always install the device via all fixation holes.
Do only use appropriate screws and make sure that the screws are properly connected with the ground.
Procedure:
Step 1: Remove the clamp rings and fixation screws from the packaging (1 pair of each accessory per
tube) and clamp the rings onto the Neon Stick.
Step 2: On the clamp rings, there are 1-2 holes for the installation.
Step 3: Hold the device with attached clamp rings onto the location where the device is to be installed.
Step 4: Mark the boreholes with a pen or a suitable tool.
Step 5: Drill the holes.
Step 6: Hold the clamp rings in the desired position and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

OPERATION

Connect the fixture to the mains with the power-plug.
With the POWER-switch, you can switch the device on and off.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards. Should you have further questions, please contact your dealer.
DANGER TO LIFE!
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
11/22 5250020K_V_1_0_4713.DOC