Lazy Susan/Burner Cover Assembly; Troubleshooting Guide - Agio 1031541 Instrucciones De Ensamblado

LAZY SUSAN/BURNER COVER ASSEMBLY

Place the lazy susan / burner cover on the table top as shown in Figure12.
WARNING: BEFORE PLACING THE LAZY SUSAN / BURNER COVER ON, MAKE SURE THE
FIREPIT HAS BEEN SHUT OFF AND THE BURNER HAS COMPLETELY COOLED DOWN.
PROBLEM
Burner won't light
Burner won't stay
lit after lighting
Jul-01-2016

TROUBLESHOOTING GUIDE

CAUSE
No Propane Gas at Burner
No Spark at Electrode
Lack of oxygen
Thermocouple not in flame
Thermocouple connection
at the main control valve is
loose
No Fire ice on Burner
REMEDY
Check that gas tank valve is open. Turn
control knob to "ON" and push control
knob in. Make sure tank has propane gas.
Check that AAA battery is installed with
negative (-) end first and has a charge.
Check that the wire is connected to the
ignition module. Check that the electrode
is not cracked or broken.
Remove excess lava rocks or fire ices
from around the ignition well.
Check that the tip of the thermocouple is
even with the top of the ignition well.
Remove any fire ice from the ignition well.
Tighten the thermocouple nut at the back
of the valve.
Cover the burner with fire ice per the
instructions.
11
Figure 12