Teka GFG2 Manual De Instrucciones página 13

Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor, paying
special attention to the grids. Afterwards, dry it
using a lint-free cloth.
Note:

Never use metallic scouring pads or
abrasive products that could damage
the surface.

Do not use scrapers with metallic
surfaces such as knives, scissors etc.
Activated charcoal filter

To install the charcoal filter, the motor
anchorage is made to coincide with
the anchor points of the activated
charcoal filter and turn it clockwise.

The carbon filter lasts from three to
six months depending on the
particular conditions of use.

The activated carbon filter can neither
be washed nor regenerated. Once it
is exhausted, it must be changed.

To replace exhausted filters with new
ones, withdraw the old one in the
reverse order to that of installation.
Tecnical Information (Fig. 3)
Dimensions: Width = 550 mm
Depth = 310 mm
Height = 175 mm
Dimensions for fitting:
Width = 517 mm
Depth = 278 mm
Electrical characteristics:
REFER TO RATING PLATE
Installation
In order to fix the cooker hood to the kitchen unit
you can choose one of these two possibilities
(fig.3):
a) To the upper part of the furniture, using
figure 3 where the position of the holes
denominated "A" is indicated. This fixation will
be made from the inside part of the cooker
hood, after disassembling the filters.
the
b) To internal laterals of the furniture through
floating holes denominated "B", wich exist in each
side of the body hood. This fixation will be made
from the inside part of the cooker hood, after
disassembling the filters.
The lower part of the extractor must be located
at a minimum height of 60 cm above the hob
for electric cookers and 65 cm for gas cookers.
If the instructions of a gas cooker indicate a
greater distance these must be observed.
To achieve optimum performance the length of
the outlet hose should not exceed 4 meters, or
include more than two 90º angles (elbows).
Although venting to the outside is
recommended, activated carbon filters may be
used, which allow the gas to be returned to the
kitchen through the outlet pipe.
13
EN