König Electronic CS500PLC4N100 Manual De Uso página 4

(Note: Do not plug this HomePlug into a power strip that has surge protection. Doing so will
degrade the power line performance. For best performance, plug the HomePlug directly into a wall
outlet.)
3. To connect to a computer, plug the other end of the Ethernet cable into an available Ethernet port
of your computer.
4. To connect to a modem / router, plug the other end of the Ethernet cable into an available Ethernet
port of your modem / router.
5. Make sure that the PLC link light is solid green.
6. Your HomePlug is now connected in the network.
Chapter 2: Individual HomePlug AV Network Setup (optional)
Since all HomePlug units do have a default security key, they will automatically be linked to all other
HomePlug units sharing the same electrical line. If there are other HomePlug units in the building
(such as in an office or apartment building), you may want to create your own individual HomePlug
network group so that other HomePlug units cannot connect to your network. The section below
describes how to use the security button for reconfiguration in some situations.
2.1 Creating a new individual HomePlug AV Network (Network AB)
Two unassociated HomePlug units (A and B) are forming a network.
The procedure is as follows:
1. Press and hold the security button on HomePlug A for about 10 seconds. Release when the power
light flashes. The password to HomePlug A has just been erased. It must be linked to your network
to adopt the new network security key.
2. Do the same for HomePlug B.
3. Now, HomePlug A and B are now networked separately.
4. Press and hold the security button on HomePlug A for 2 seconds and then release.
5. The power light of bridge A starts to flash.
6. Within 120 seconds, press and hold the security button on HomePlug B for 2 seconds and then
release.
7. Both HomePlug A and B are now networked together.
4