DeWalt DCD771 Manual De Instrucciones página 38

Voltage (Volts)
Total length of cord in meters (m)
120–127V 0–7
220–240V 0–15
Rated Ampere Minimal cross-sectional area of the
range
0–6A 1.0
6–10A 1.0
10–12A 1.5
12–16A 2.5
• Do not place any object on top of the charger or place the
charger on a soft surface that might block the ventilation
slots and result in excessive internal heat. Place the charger
in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
• Do not operate the charger with a damaged cord or plug.
• Do not operate the charger if it has received a sharp blow,
been dropped or otherwise damaged in any way. Take it to
an authorized service center.
• Do not disassemble the charger; take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 120V
household electrical power. Do not attempt to use it on any
other voltage. This does not apply to the vehicular charger.
7–15 15–30 30–50
15–30 30–60 60–100
cord in meters (mm 2 )
1.5 1.5 2.5
1.5 2.5 4.0
1.5 2.5 4.0
4.0 Not Recommended
Chargers
Your tool uses a D WALT charger. Be sure to read all safety
E
instructions before using your charger.
Charging Procedure (Fig. 1)
1. Plug the charger into an
appropriate outlet before
inserting the battery pack.
2. Insert the battery pack (H)
into the charger, as shown
in Figure 1, making sure
the pack is fully seated in
charger. The red (charging)
light will blink continuously,
indicating that the charging
process has started.
3. The completion of charge
will be indicated by the red light remaining ON continuously. The
pack is fully charged and may be used at this time or left in the
charger.
Indicator Light Operation
DCB106
PACK CHARGING
PACK CHARGED
DCB107
PACK CHARGING
PACK CHARGED
HOT/COLD DELAY
36
FIG. 1
H